Bios Update (Deutsch) 
===========================================================================
1: Erstellen Sie eine Bootdiskette (z.B. format a: /s) ohne die autoexec.bat und config.sys Datei. Kopieren Sie danach die Phlash.exe, Platform.bin und die entpackte Biosdatei 
(z.B. 83-0110a.rom) auf die Bootdiskette. 

2: Schalten Sie nun das Notebook aus und starten anschlieend wieder neu von der Bootdiskette, die Sie in Schritt 1 erstellt haben. Geben Sie dann die folgende Befehlszeile ein um den Updatevorgang zu starten: phlash /mode=3 83-0109.rom (bedeutet das Sie auf die Version 83-0109 updaten) und drcken Sie dann [Enter]

3: Jetzt startet der flash-Vorgang, d.H. der Biosbaustein wird neu beschrieben. Sobald dieser beendet ist werden Sie aufgefordert eine beliebige Taste zu drcken. Sollte sich das Notebook nun nicht automatisch ausschalten, bettigen Sie einfach den Ein/Ausschalter.

4: Wenn Sie nun den Rechner wieder hochfahren drcken Sie F2 um ins Bios zu gelangen. Im Men "Exit" sollten Sie dann "Load Setup Defaults" ausfhren (ldt die Bios standard Einstellungen) und anschliessend mit "Exit Saving Changes" die nderungen speichern und das Bios verlassen.


!!!Achtung verwenden Sie dieses Phlash nicht fr die S8200/S8600 Serie!!!


BIOS Flashing Steps (English)
===========================================================================
1: Make a DOS boot diskette without autoexec.bat and config.sys files. 
   Copy the PHLASH.EXE, PLATFORM.BIN, and unzipped BIOS 
   image(ex.0404.ROM) files to this diskette. 

2: Turn the system off, then boot the system using the boot diskette
   you just created. Then type
   PHLASH /MODE=3 0404.ROM(say if you wanna to update to rev. 0404) 
   and press [ENTER]. 

3: It will now update the flash BIOS. If flash memory has been
   successfully programmed, it will ask you to press any key to power off
   the system. If the system does not off, turn the power off then on.  

4: Assuming that you have successfully flashed the BIOS. After the system
   reboots, hit [F2] to enter the CMOS Setup. At this point, go to
   "Load Setup Defaults" field at "Exit" sub-menu. Then save and exit Setup.